Brown-Sharpe SMT
Division of Lester Detterbeck Enterprises Ltd.
Website by North Country Website Design. _
Copyright © 2016 Brown-Sharpe SMT. A division of Lester Detterbeck Enterprises, Ltd. All Rights Reserved.
Back Rests For Turrets
No. 234 Roller Back Rests for Turrets
These tools are held in the turret to support the work and prevent it from springing under cross
slide operations. The tools are provided with rollers to eliminate the possibility of rub marks and
scoring that can occur with the "V" type of back rest. Rolls and roll holders are the same as used
on Nos. 51 and 52 Roller Back Tools, thereby reducing your inventory of spare parts. A clamp
screw is provided for holding a stop in the shank.
No. 235 'V' Back Rests for Turrets
Turret back rests, held in the turret, support the stock being turned and prevent it from
springing under cross slide operations. Shanks are arranged to hold stock stop or end cutting
tools.
Back rests have a "V" on both ends to provide full capacity with a single set of rests.
Brown-Sharpe SMT
Division of Lester Detterbeck Enterprises Ltd.
Website Design by North Country Website Design. _
Copyright © 2016 Brown-Sharpe SMT.
A division of Lester Detterbeck Enterprises, Ltd.
Back Rests For Turrets
No. 234 Roller Back Rests for Turrets
These tools are held in the turret to support the
work and prevent it from springing under
cross slide operations. The tools are provided
with rollers to eliminate the possibility of rub marks and scoring
that can occur with the "V" type of back rest. Rolls and roll
holders are the same as used on Nos. 51 and 52 Roller Back
Tools, thereby reducing your inventory of spare parts. A clamp
screw is provided for holding a stop in the shank.
No. 235 'V' Back Rests for Turrets
Turret back rests, held in the turret, support the
stock being turned and prevent it from springing under cross
slide operations. Shanks are arranged to hold stock stop or end
cutting tools.
Back rests have a "V" on both ends to provide full capacity with a
single set of rests.
